Flanged Flares - AWWA C110, DI (in)

Written by Matt Milbury on . Posted in Ductile Iron Flanged Fitting Datasheets

Flanged flares - AWWA C110, DI Datasheet

  • Flanged flare fittings are not included in AWWA C110/A21.10
  • For flange dimensions see Flange - ANSI Class 125, C110, DI
  • AWWA C110/A21.10 - Ductile-Iron and Gray-Iron Fittings (3" to 48")
  • AWWA C104/A21.4 - Standard for Cement-Mortar Lining for Ductile-Iron Pipe and Fittings for Water
  • ASME B16.1 - Gray Iron Pipe Flanges and Flanged Fittings: Classes 25, 125, and 250 (Flange surfaces shall be faced and drilled in accordance with ANSI Class 125)
  • All ductile iron flanged fittings shall be rated for water pressure of 250 PSI.
  • Flanged ductile iron fittings in 24 inch and smaller sizes may be rated for 350 psi with the use of special gaskets.
data 90 flare flg diFlange & Flare 90 Elbow
data 90 flare flg di 1
data flare flg diFlange & Flare
data flare flg di 1
 
 
 
 
 
 
 
 
 
 
 
 

Flange and Flare 90° Elbow 
Run SizeMNPApprox. Weight (lb)
3 7.5 5.5 8.5 25
4 9 6.5 9.5 40
6 11 8 12 75
8 13.5 9 13 110
10 16 11 15 170
12 19 12 16 255
14 21 14 22 450
16 23.5 15 23 545
18 25 16.5 24.5 675
20 27.5 18 26 860
24 32 22 30 1195
30 38.8 25 38 2070
36 48 28 38 2900
Flange and Flare Piece
Run SizeRSApprox. Weight (lb)
3 7.25 8 20
4 9 8 30
6 11 8 45
8 13.5 10 75
10 16 10 115
12 19 12 155
14 21 16 225
16 23.5 16 330
18 25 16 355
20 27.5 18 465
24 32 18 600
30 38.75 24 900
36 46 24 1200