Pipe - DI, ANSI, Pressure Class (in)

on . Posted in Pipe & Tubing Datasheets

  • This is for the nominal thickness for standard pressure classes of ductile iron pipe.
  • Per ANSI/AWWA C150/A21.50 the thicknesses above include the 0.08" service allowance and the casting tolerance listed below by size ranges.
  • Dimensions and weights of thickness classes are found at Pipe - DI, ANSI, Thickness Class.
  • Pressure classes are defined as the rated water pressure of the pipe in psi.
  • The thicknesses shown are adequate for the rated water working pressure plus a surge allowance of 100 psi. Calculations are based on a minimum yield strength of 42,000 and a 2.0 safety factor times the sum of the working pressure and 100 psi surge allowance.
  • * Calculated thickness for these sizes and pressure ratings are less than those shown below. Presently these are the lowest nominal thicknesses available in these sizes.

 

Pipe - DI, ANSI, Pressure Class (in)

Pipe Size

(NPS)

Outside Diameter

(in)

Pressure Class - Nominal Thickness (in)Casting Tolerances

(in)

150200250300350
3 3 31/32 - - - - 0.25 * 0.05
4 4 13/16 - - - - 0.25 * 0.05
6 6 29/32 - - - - 0.25 * 0.05
8 9 1/16 - - - - 0.25 * 0.05
10 11 3/32 - - - - 0.28 0.06
12 13 3/16 - - - - 0.28 0.06
14 15 5/16 - - 0.28 0.30 0.31 0.07
16 17 13/32 - - 0.30 0.32 0.34 0.07
18 19 1/2 - - 0.31 0.34 0.36 0.07
20 21 19/32 - - 0.33 0.36 0.38 0.07
24 25 13/16 - 0.33 0.37 0.40 0.43 0.07
30 32 0.34 0.38 0.42 0.45 0.49 0.07
36 38 5/16 0.38 0.42 0.47 0.51 0.56 0.07
42 44 1/2 0.41 0.47 0.52 0.57 0.63 0.07
48 50 13/16 0.46 0.52 0.58 0.64 0.70 0.08
54 57 9/16 0.51 0.58 0.65 0.72 0.79 0.09
60 61 5/8 0.54 0.61 0.68 0.76 0.83 0.09
64 65 21/32 0.56 0.64 0.72 0.80 0.87 0.09

 

Piping Designer Logo 1