National Pipe Thread

on . Posted in Fastener

NPT pipe threades or American Standard Taper Pipe Threads are used frequently in the oil and gas industry.  The threads have a taper to not only provide a method of mechanical joining of two fittings or pipes but also to provide a leak proof joint.  In order to accomplish this, the threads become shallower the farther they are from the end of the pipe or fitting.  If you were to take the cross section of a NPT threaded end, you would see that the bottoms of the threads aren't on a cylinder, but a cone.  This is the taper which is 1/16 inch per inch, which is equivalent to 3/4 inch per foot.

Because of the taper, a pipe can only screw into a fitting a certain distance before it jams.  This is much different than threading a nut on a bolt. ASME B1.20.1 specifies the effective thread distance.  It also specifies the engagement distance which is the distance the pipe can be screwed in by hand, without much effort.  Engineers and piping designers need to take this into account when they are creating drawings.  Field workers need to know how many turns it takes to make up the fitting by hand or with a wrench.

 

National Pipe Thread Dimensions

Nominal sizeActual ODThreads per inchLength of engagement hand tightHand tight turnsWrench makeup turnsLength of effective thread
1/16 0.3125 27 0.160 - - 0.2611
1/8 0.405 27 0.180 4.50 2.50 0.260
1/4 0.540 18 0.200 4 3 0.401
3/8 0.675 18 0.240 4.50 3 0.408
1/2 0.840 14 0.320 4.50 3 0.534
3/4 1.050 14 0.340 4.50 3 0.546
1 1.315 11.5 0.400 4.50 3.25 0.682
1-1/4 1.660 11.5 0.420 4.50 3.25 0.707
1-1/2 1.900 11.5 0.420 4.50 3.25 0.724
2 2.375 11.5 0.436 5 3 0.756
2-1/2 2.875 8 0.682 5.50 3 1.136
3 3.500 8 0.766 6 3 1.2000
3-1/2 4.000 8 0.821 6.50 3.50 1.2500
4 4.500 8 0.844 6.75 3.50 1.3000
5 5.563 8 0.937 7.50 3.75 1.4063

 

standards

  • ASME
    • ASME B1.20.1 - Pipe Threads, General Purpose, Inch

Piping Designer Logo 1

 

Tags: Pipe